Blackmagic Design ATEM Live Installations- Und Bedienungsanleitung Seite 124

4 Use the arrow buttons to the left of the LCD button to navigate all the available wipe
properties including position, symmetry and border source.
5 Perform the transition as an auto transition or manual transition from the transition
control block.
Wipe transition parameters
Rate
Symmetry
Position
Reverse
FlipFlop
Border
Softness
The border source used in a wipe transition can be any source in the switcher. For example,
a thick border with the media player as its source can be used for sponsorship or branding.
ATEM Constellation 8K has no borders for SuperSource in 8K. It has 4 stinger transitions in
HD and Ultra HD modes and one in 8K.
On ATEM 1 M/E and 2 M/E switchers, the stinger transition uses a clip from the media player to
perform a transition. The clip is normally a graphic animation that is keyed over the background.
As the animation plays, when it is full screen, a cut or mix of the background is performed under
the animation. For example, this type of transition is very popular in sports productions for
transitioning in and out of instant replays. The stinger transition takes advantage of a special
keyer that is built into the transition block, leaving all of the upstream and downstream keyers
available for compositing your output. The following section explains how to build and perform
stinger transitions.
The length of the wipe transition in seconds and frames.
Symmetry can be used to control the aspect ratio of the pattern.
For example, adjusting the symmetry will allow you to change a circle into
an ellipse. On the advanced panel symmetry can be adjusted using the z
axis of the joystick or via the control knob.
If the wipe pattern has positioning then the joystick or control knobs on
the advanced panel or the x position: and y position: boxes in the transition
palette of the software control panel can be used to move the center of
the pattern. Moving the joystick dynamically updates the x and y position
display in the software control panel.
Reverse changes the progression of closed patterns such as circles,
diamonds and boxes so that the pattern closes in from the edges of the
screen toward the center. The text will illuminate orange when selected.
When FlipFlop mode is toggled on, the transition changes between normal
to reverse every time the transition is executed. The text will illuminate
orange when selected.
Width of the border.
The edges of the wipe pattern can be adjusted between sharp and fuzzy
by adjusting the softness parameter.
Operating your ATEM Switcher 124