Herunterladen Inhalt Inhalt Diese Seite drucken

Using The Software Control Panel - Blackmagic Design ATEM Live Installations- Und Bedienungsanleitung

Produktionsmischer
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 621
In the settings window, you can also set the switcher video standard. This is the master video
standard that the whole switcher operates at, and it's very important you set this to the same
video standard as your video inputs. More details on setting the video standards are included
later in this manual.
The switcher settings also let you customize your multi view. The arrangement of the multi view
screen can be changed by clicking on the presets at the bottom right of the M/E 1 Control Panel,
or the right side of the Settings window on the M/E 2 Control Panel. On all ATEM production
and broadcast studio switchers, the arrangement for the 8 smaller video views are fully routable
allowing you to view any source in the switcher. ATEM Constellation 8K is even more flexible,
giving you the option to customize the multi view to show any combination of 4, 7, 10, 13 or 16
sources in the switcher.
This lets you monitor cameras, internal sources, media players and even aux outputs on a
single monitor. Multiview saves space when doing portable location based events because you
only need a single monitor.
If you are connecting Blackmagic HyperDeck disk recorders to your switcher, you can use the
switcher settings to enter their IP address, view their connection status, and change the frame
offset and auto roll settings so you can switch cleanly to a HyperDeck video source. For more
information about using HyperDeck disk recorders with your ATEM switcher, refer to the
'HyperDeck control' section of this manual.
You can also set your switcher's remote behaviour using the 'remote' tab. This allows you to use
the RS-422 port on your switcher to control pan, tilt, zoom heads or legacy GVG100 hardware
such as linear edit suites.
Switcher settings are explained in detail in 'Changing Switcher Settings' of 'Using
ATEM Software Control' section of this manual.

Using the Software Control Panel

The switcher window is the main control interface for the switcher. During live production,
the switcher window can be used to select sources and take them to air.
You can select the transition style, manage upstream/downstream keyers and turn on/off the
fade to black. The palettes on the right hand side of the interface are where you adjust
transition settings including transition rates, adjust color generators, control media players,
and adjust the upstream and downstream keyers as well as control fade to black rate.
Mix Effects
The Mix Effects block of the switcher tab contains all the source select buttons for the program
and preview buses, allowing external inputs or internal sources to be selected for next
transition previewing or switching to air.
If your switcher has 2 Mix Effects panels, you can optimize the interface to show both, or select
each panel by clicking on the Mix Effects 1 or Mix Effects 2 buttons at the top of the interface.
When both panels are visible, the Mix Effects 1 or 2 buttons will move to the
processing palettes.
Using ATEM Software Control
45

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis