Blackmagic Design ATEM Live Installations- Und Bedienungsanleitung Seite 68

TRS Inputs
If you are plugging in an audio source via RCA using an RCA to TRS adapter, then you can
change the input level on the TRS input from TRS to RCA. This boosts the signal at the input to
compensate for the lower output levels from equipment using RCA connectors, for example
HiFi audio equipment.
Split Audio
On ATEM Constellation 8K you can split a mono input signal into two separate mono channels.
This is helpful for mixing a mono input into both channels on the stereo master output.
Click on the desired input checkbox to split the channels for that input.
Adjusting the Media Pool Clip Length
For models that support media clips, the media pool features two clips that share the same
pool of memory. ATEM Constellation 8K can store two 8K clips and four HD or Ultra HD clips.
By default, each clip receives equal amounts of the available memory which determines the
maximum number of frames. If you need a clip to be longer, adjust the balance of frames.
It's worth remembering that lengthening one clip will shorten the other.
Setting the Media Pool Clip Length
Clip Length Table
ATEM Switcher
ATEM Constellation 8K
ATEM 4 M/E Broadcast Studio 4K
ATEM 1 M/E and 2 M/E Production Studio 4K
Camera Control Auxiliary Output
If your switcher features auxiliary outputs, you can select which one will monitor the
ATEM Camera Control output. Set your desired aux output by opening 'settings', then selecting
from the 'auxiliary for camera control output' drop down menu. Auxiliary output buttons can also
be renamed in settings by adjusting the input labels. With ATEM Constellation 8K, you can
select any SDI output for camera control.
You can output the camera control via any of your switcher's auxiliary outputs.
Video Format Clip Length
720p 3200 frames
1080i, 1080p 1600 frames
2160p 400 frames
4320p 100 frames
720p 3200 frames
1080i, 1080p 1440 frames
2160p 360 frames
SD 900 frames
720p 360 frames
1080i 180 frames
Using ATEM Software Control 68