Throttle Cable Adjustment - Husqvarna TE 250 2008-I.E. Merkmale, Gebrauch, Wartung

Cap6_GB 9-07-2007 16:09
Periodically check the connecting hoses (see "Periodical main-
tenance card"): this will avoid coolant leakages and conse-
quent engine seizure: If hoses (A) show cracks, swelling or
hardenings due to sheats desiccation, their replacement shall
be advisable.
Check the correct tightening of the clamps (B).
A
B
Pagina 33

THROTTLE CABLE ADJUSTMENT

To check the correct adjustment of the throttle operate as fol-
lows:
- remove the upper rubber cap (1);
-
by moving cable (2) back and forth check for 2 mm. clearance;
- should the clearance be incorrect, unblock the counter ring-
nut (3) and turn the adjusting screw (4) (by unscrewing it,
the clearance is reduced, while by screwing screw (4) it is
increased);
- tighten the counter ring-nut again (3).
WARNING*: Operation with damaged throt-
tle cable could result in an unsafe riding
condition.
WARNING*: Exhaust gas contains poisonous
carbon monoxide gas. Never run the engine
B
in a closed area or in a confined area.
A
NOTE
In case of throttle control cables (1) and (2) replacement it is
necessary to respect, during reassembly, the measure Á
(10mm/0.4 in.), as shown in the picture. Then reassemble
guard cover (B) using screw (3) and adjust throttle control
cables on handlebar as described at side.
To replace throttle control cables, first remove tha fuel tank as
shown on pages 35, 36.
33