Riding - Husqvarna TE 250 2008-I.E. Merkmale, Gebrauch, Wartung

Cap5_GB 9-07-2007 16:25

RIDING

BEFORE EVERY RIDE MAKE FOLLOWING CHECKS
WARNING!
Before each ride, to prevent accidents or failures during ride,
make sure to go through following list.
1. Check all fluids
A. Engine-transmission oil level
B. fuel level
C. coolant level
Make sure all caps are properly adjusted.
WARNING*: Don't remove radiator cap
when hot!
2. Check all controls
A. Throttle handgrip
B. Clutch lever
Make sure cables are not damaged and turn smoothly.
3. Check brakes
Look for brake fluid leaks and worn hoses. Check for prop-
er functioning.
4. Check suspensions
Compress fork and rear suspensions. Look for oil leaks and
ensure proper functioning.
5. Check wheels
Check spokes and look for worn bearings.
Check rims and tyres.
Check tyre pressure.
6. Check chain rollers and sprockets
Check wear on chain rollers and sprockets
Ensure chain is correctly adjusted and lubricated.
7. Check air filter and intake system
Check that air filter is clean
Check all rubber connections and clamps.
Pagina 23
8. Check exhaust system
Check hook up, look for cracks
Check muffler.
9. Check torque
A. Spark plug
B. Cylinder-head nuts
C. General check of torque
10.Check steering action
Check bearing play.
11. Check the electric system (TE- SMR). Start the
engine and check that the front and rear lamps, the stop
light, the turn signals the cluster warning lights and the
horn are working correctly.
WARNING*: Failure to perform these checks
every day before you ride may result in
serous damage or a severe accident.
RUNNIN IN
Before using the motorcycle for sporting activities run in the
engine for two hours at least to increase the life and the per-
formance of the engine.
During the first half-hour of driving we advise keeping a low
speed and avoiding sudden accelerations. Never open the
throttle fully.
Change the oil and carry out all the necessary maintenance op-
erations. After the first half-hour of driving, lightly increase the
rev number, but never run the engine at full throttle. Never
keep low speeds when the high gears are inserted.
Slowly drive the motorcycle for two hours before using it for
sporting activities.
CHECKS WHILE RUNNING IN
- SPOKE TENSION OF WHEELS (see page 78);
- TIGHTENING OF WHEELS (see page 92-93);
- FORK PIN TIGHTENING (see page 92);
- CHAIN ADJUSTMENT (see page 51);
- STEERING BEARING PLAY (see page 40);
- HANDLEBAR TIGHTENING (see page 92);
- ENGINE GRIP TO FRAME (see page 92);
- SUCTION FITTING GRIP (see page 92);
- HEAD AND CYLINDER NUTS GRIP (see page 92);
OFTEN CHECK THE BATTERY CHARGE CONDITION (see page 86).
23