Yamaha WR450F Fahrer- Und Wartungshandbuch Seite 508

TRANSMISSION, SHIFT CAM AND SHIFT FORK
c
2. Install:
NOTE:
• Apply the molybdenum disulfide oil on the
• Apply the lithium soap base grease on the O-
3. Install:
NOTE:
• Be sure the circlip sharp-edged corner a is
• Install the circlip with its ends c settled
c
4. Install:
NOTE:
• Apply the lithium soap base grease on the oil
• When installing the spacer into the crank-
4 - 104
• 2nd wheel gear (26T) 1
• 4th wheel gear (21T) 2
• 3rd wheel gear (21T) 3
• 5th wheel gear (21T) 4
• 1st wheel gear (29T) 5
• O-ring 6
To drive axle 7.
inner and end surface of the idler gear and
on the inner surface of the sliding gear, then
install.
ring.
• Plain washer 1
• Circlip 2
New
positioned opposite side to the plain washer
and gear b.
evenly on the spline crests.
• Collar 1
seal lip.
case, pay careful attention to the crankcase
oil seal lip.
ENG