7. Device use – ALL MODELS
Add Oil To Engine
The engine is shipped without oil. Do not start the engine before adding oil. Please refer to your
engine manual for the proper grade of oil to add.
1. Make sure the power trackbarrow is on a flat, level surface.
2. Remove the oil fill cap/dipstick to add oil.
3. Using a funnel, add oil up to the FULL mark on the dipstick. (See engine manual for oil capacity, oil
recommendation, and location of fill cap.)
DO NOT OVERFILL. Check engine oil level daily and add as needed.
Add Gasoline To Engine
Gasoline is highly flammable and explosive. You can be burned or seriously injured when handling
fuel. Use extreme care when handling gasoline.
Fill the fuel tank outdoors, never indoors. Gasoline vapours can ignite if they collect inside an
enclosure. Explosion can result.
1. The engine must be off and allowed to cool at least two minutes before adding fuel.
2. Remove the fuel filler cap and fill the tank. (See engine manual for fuel capacity, fuel recommendation,
and location of fuel cap.)
IMPORTANT: DO NOT OVERFILL!
This equipment and/or its engine may include evaporative emissions control system components, require
d t o meet E PA and/ or CARB regulations, that will only function properly when the fuel tank has been
filled to the recommended level. Overfilling may cause permanent damage to evaporative emissions
EN
1 – Open
2 – Closed