Safety Informations - TR-Electronic LA Serie Gesamt-Bedienungsanleitung

Basic safety instructions

2.9 Safety informations



The measuring system contains electrostatically endangered circuit
elements and units which can be destroyed by an improper use.


Disposal
If disposal has to be undertaken after the life span of the device, the respective
applicable country-specific regulations are to be observed.
 TR-Electronic GmbH 2007, All Rights Reserved
Page 38 of 51
Destruction, damage or malfunctions of the measuring system and
risk of physical injury!
 De-energize the system before carrying out wiring work or opening and
closing electrical connections.
 Do not carry out welding if the measuring system has already been
wired up or is switched on.
 Series LMRB-27: Position jumps, faulty position output!
Only interface units and sensors with the same order number and
-
the same serial number according to the name plate may be
connected together.
 Ensure that the area around the assembly site is protected from
corrosive media (acid, etc.).
 Avoid any shocks (e.g. hammer-blow) on the measuring system while
mounting.
 Do not bend the sensor rod.
 Do not install the measuring system next to magnetic fields.
 Do not open the measuring system.
Contacts of the measuring system connection contacts with the fingers are to
be avoided, or the appropriate ESD protective measures are to be applied.
TR-ELA-BA-DGB-0004 v16
Printed in the Federal Republic of Germany
03/17/2021