Philips DP6000 Bedienungsanleitung Seite 9

• Press twice if the receiver displays its
last received 48 character message.
While the telemetry message is displayed,
the telemetry icon
ON and NO message number displayed.
Back-lighting
Back-lighting for the alphanumeric display is
incorporated for use in badly lit situations.
If installer enabled for back-lighting, the
display will illuminate with every incoming
call containing alphanumeric information
and when scrolling through the message
stack.The light will switch OFF approx. 8
seconds after the bleep, or after 10 seconds
if the RESET/RECALL button has not been
pressed.
SPEECH MESSAGES
(type No. dependent)
Your receiver can be installer
programmed to receive speech or not to
receive speech. If enabled for speech,
speech can be relayed from the caller via
the receivers built-in loudspeaker. If speech
is enabled in the receiver this is indicated
under the Speech ON/OFF icon
(fig.3(F)).To terminate a speech call press
the RESET/RECALL button. Normally
speech reception is ended by a reset
speech call from the central.
1-12
will be constantly
If the RESET/RECALL button is pressed in
error during a speech call, press the
RESET/RECALL button again within 8-
second to re-open the speech channel.
OUT -OF RANGE
DETECTION
All receivers incorporate an 'Out-
of range' function (see note) alerting the
user when the receiver has been taken
out-of-range of the system transmitters.
Out-of-range is indicated as follows:
NOTE: The 'out-of-range' function is only
available if installed in your system.
• Visual display: Alphanumeric display
shows a flashing 'out-of-range' icon
(see fig.3(B)). Numeric display
only version: shows the following: '0-0-
0' followed by '-0-0-' flashing.
• Emits a bleep pattern for approx. 1
minute.This bleep can be reset by
pressing the RESET/RECALL button.
To RESET the 'out-of-range' condition
proceed as follows:
• Bring the receiver back into range of
the system.
• If not brought back in range within 30
minutes the receiver emits a loud
1-13