Philips DP6000 Bedienungsanleitung Seite 8

receivers LED emits a short flash to
indicate that the message also contains
alphanumeric information.
DELETING MESSAGES IN STACK
If installer enabled, messages in the stack
can be deleted as follows:
• Scroll using the RESET/RECALL
button until the message to be
deleted is displayed.
• Once displayed, press the
RESET/RECALL button again for
approx. 3 seconds to delete the
displayed message. An alert bleep
indicates the message has been
deleted.
DELETING ALL MESSAGES IN
STACK
If enabled ALL messages can be deleted as
follows:
• When the receiver is placed in the
storage rack.
• When the receiver is switched OFF.
NOTE: While the receiver is in the
storage rack, new messages will be stored
in the memory stack.When taken out of
the rack it will emit two attention bleeps to
indicate to the user that new messages
have been received.
1-10
TELEMETRY MESSAGES
(Mailbox)
The telemetry function (Mailbox) is
only available for versions with
alphanumeric display.This function, if
enabled, provides receiver holders with
continuous 'up-to-date' information (e.g
process control (upto 48-character)).
A paged call with telemetry information is
defined by its bleep pattern (normally a
silent call). In case it is sent as a silent call
the telemetry message is written directly to
the memory stack and not to the display.
The user is informed of such a message
with a flashing telemetry message icon
(fig.3 (G))
If the telemetry message is sent with a
normal bleep pattern, the receiver emits an
alert (bleep/vibrates/LED) and displays the
message on the alphanumeric display
(telemetry message icon is ON).
If the receiver is in standby mode, the
telemetry message can be displayed from
the memory stack as follows:
• Press the RESET/RECALL button once
if the receiver display its normal paging
address or the last received message
(max. 24 characters).
1-11