Safety Notes - Westfalia 82 38 70 Bedienungsanleitung

Please note the included General Safety Notes and the
following safety notes to avoid malfunctions, damages or physical
injuries:
 Make sure the voltage corresponds to the type label on the unit.
 Persons with limited physical, sensorial or mental abilities are not allowed to
use the unit, unless they are supervised and briefed for their safety by a
qualified person.
 Disconnect the machine from the power supply before inserting the tool,
cleaning or servicing it.
 Do not use grinding discs with a diameter larger than 25.1 mm!
 Do not force the tool.
 Use clamps or a vice to hold the workpiece.
 The use of any accessory or attachment other than those recommended in this
instruction manual may present a risk of personal injury.
 Do not touch the rotating chuck and the tool bit in it, as this may cause cuts or
burns.
 Always hold the drill and milling machine firmly in your hand. The tool bit can
suddenly get stuck, which may cause injuries.
 During operation always wear safety goggles and if
necessary ear protectors and a face mask, depending on
the used material.
 Keep the drill and milling machine out of reach of children. The machine is not
a toy.
 Do not press the locking button while the machine is running!
 Operate the unit only indoors or in dry areas.
 Do not stress the cord. Do not bend the cord and keep it away from hot and
sharp surfaces. Do not wind the cord around the unit.
 Keep the work area clean. Dress appropriately.
 Should the unit become damaged do not use it and have it repaired by a
professional or contact our customer support department. Do not disassemble
the unit or try repairing it yourself.

Safety Notes

3