Before First Use; Inserting The Saw Blade; Start-Up; Turning On/Off - Westfalia M1Q-80 Bedienungsanleitung

Before first Use

Unpack the saw and check the unit for any damage in transit. Dispose of
packaging materials or store it out of reach of children. Plastic bags etc. may
become a deadly toy for children.
Inserting a Saw Blade
1. Before undertaking any work on the machine,
disconnect it from the power mains.
2. Insert the included Allen spanner through the slots
in the perspex cap (11). Loosen the two Allen head
screws of the saw blade holder (13) counter clock-
wise until the saw blade can be inserted into the
holder all the way. After that, retighten the screws.
Retighten the screws alternating until the saw blade
is tight.
Please note: The saw blade will become very hot during cutting due to friction.
Pay attention for that when removing the saw blade. Protect yourself with
protective gloves if necessary.

Start-Up

Please note the power supply voltage. Make sure that the voltage on the name
plate of the power supply complies with the power supply voltage of your power
source. Units marked with 230V can be operated with 220V - 240V.

Turning ON/OFF

1. Press the ON/OFF switch (2). The ON/OFF switch can be locked in position
for continuous operation by pressing the locking button (3).
2. Press ON/OFF switch again to release the locking button.

Adjusting the Stroke Rate

Use the speed regulator (1) to adjust the stroke rate. The
required stroke rate of the saw blade depends on the
material and the saw blade used. You should find it out by
testing in practice.

Adjusting the Pendulum Stroke

The pendulum is adjusted with the pendulum stroke adjusting lever (8). The
pendulum gives the saw blade a horizontal pendulousness. At level 0 the saw
Operation
8