Safety Notes - Westfalia M1Q-80 Bedienungsanleitung

Please note the included General Safety Notes and the following
safety notes to avoid malfunctions, damage or physical injury:
Make sure the voltage corresponds to the type label on the unit.
Do not cut or saw where there may be hidden electricity, gas or water
utility services.
Only use saw blades that are suitable for this model. Do not cut with
blunt, damaged or bent saw blades. Make sure the saw blade is firmly
tightened before switching on the unit.
Do not attempt to cut workpieces so small that they cannot be securely
fastened. Do not support the workpiece with your hand or your foot. There
is danger of kick-back! Do not reach over the front of the unit or place ei-
ther hand in the vicinity of the saw blade, e.g. to remove lose splinters,
swarf/shavings or jammed workpiece fragments.
Always unplug the power plug when not in use, before maintaining or
changing the saw blade.
Only use extension cables which are approved for outdoor operation. Use
approvable extension cable with a cable quality of H07 RN-F; 3-1.5 mm
Ask your electrician.
For using the unit, we recommend the use of an RCD with a residual
current < 30 mA. In Switzerland the utilisation of an RCD is obligatory.
Do not jam the cord or pull cord around edges. Do not pinch the power
cord in any way and keep it away from hot surfaces. Make sure
the cord does not become a tripping hazard.
For your safety, please wear Safety Goggles, a dust mask and
ear protection.

Safety notes

7
2
.