Miele PDR 914 SOM Gebrauchs- Und Aufstellanweisung Seite 82

en - Supervisor level
A communication module can be used to select the programme from an external ter-
minal.
Programme packages
This allows you to specify the scope of the tumble dryer programme. You can select all of
the programmes or individual programmes from the relevant programme packages.
The tumble dryer's additional scope of programmes can be configured. The programmes
are listed under "Programme chart".
Favourite programmes
After switching on, you can also select a programme via:  Favourites.
12 programmes can be stored as favourites based on your own priorities and require-
ments.
These favourites will also be made available in the control options
- Launderette ext. (12 prog)
- Launderette, basic (4 prog) (the first 4 of the 12 favourites).
You can specify the control option under
Tip: You can assign a different colour to each programme. In this case, the Prog. colour al-
location setting must be set to On.
Changing Favourite programmes
Select the programme you wish to change or replace.

Confirm the programme or the setting to be changed.

Another menu opens, enabling you to select a new programme or change the parameters.
Confirm with the

Your selection is now active.
Special programmes
You can put together 5 special residual moisture or time-controlled programmes and as-
sign your own programme names.
First, enter the programme name.
Select the special programme you want to change.

The Save as menu opens.
Use the letters and symbols below the line to enter the name.

Touch the sensor control.
Save

You can now enter the parameters for a Res. moisture programme or Timed drying.
The 5 special programmes are pre-programmed at the factory. You can change these spe-
cial programmes.
The special programmes are added to the programme packages. Enter the name and set-
tings of your special programme into the "Special programmes" table in the "Programme
overview" chapter.
Res. moisture programme
82
Save sensor control.
:
.
Controls