Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4 . Remove the blade bar
. To disassemble, hold the blade bar
10 ]
[
tilted upwards at an angle of approx . 45
degrees in order to be able to remove the
saw chain
more easily from the chain
[
10 ]
sprocket .
5 . Replace the blade bar
blade bar and saw chain as described
under "Assemble the blade bar and saw
chain " .
NOTE
The tensioning of the saw chain is
u
described in the "Assembly" section .
˜ Sawing techniques
˜ General information
NOTE
Observe noise protection rules and other
u
local regulations when working with the
tool . Local regulations may require a
suitability test . Check with the forestry
administration .
Dirt, stones, loose bark, nails, clips and
wires must be removed from the tree .
Always stand above the tree trunk when
sawing on slopes .
To keep total control while sawing through,
reduce the pressure at the end of the cut
without loosening your grip on the handles
of the pruning saw . Make sure the saw
chain does not touch the ground . After
finishing the cut, wait until the pruning saw
comes to a stop before removing it .
Always switch off the motor of the pruning
saw before changing between trees .
You will have better control over the
product if you saw using the lower edge of
the blade bar (chain in pulling direction) .
The saw chain must not touch the ground
or any object while sawing through the
material or thereafter .
Ensure that the saw chain does not get
stuck while sawing . The log must not break
or splinter .
434668_2304_CZ_SK_HU_SI_02.indb 19
434668_2304_CZ_SK_HU_SI_02.indb 19
and saw chain
9 ]
[
9 ]
[
and install the
9 ]
[
Please also observe the precautionary
measures to protect against kickback (see
the safety information) .
For sawing work on hillsides, always stand
in the area above the log . To keep total
control while sawing through, reduce
the pressure at the end of the cut without
loosening your grip on the handles of the
pruning saw . Make sure the saw chain does
not touch the ground After finishing the cut,
wait until the saw chain comes to a stop
before removing it . Always switch off the
motor of the pruning saw before changing
between trees .
m
WARNING!
If the saw chain gets stuck, do not
u
attempt to pull out the product with force .
There is a risk of injury . Turn the motor off
and use a lever arm or wedge to release
the product .
˜ Cut to length
Cutting to length means sawing felled tree
trunks into small sections . Ensure that you have
secure footing and balance your body weight
evenly on both feet . If possible, the trunk should
be protected and supported by branches, logs
or wedges .
Make sure that the saw chain does not
touch the ground when sawing .
Make sure you have good footing and
stand above the trunk on sloping terrain .
To keep total control while sawing through,
reduce the pressure at the end of the cut
without loosening your grip on the handles
of the pruning saw . After finishing the cut,
wait until the saw chain comes to a stop
before removing it . Always switch off the
motor of the pruning saw before changing
between trees .
GB
19
11/3/2023 12:17:24 PM
11/3/2023 12:17:24 PM
Werbung
