Parkside PGHSA 20-LI B1 Bedienungsanleitung Seite 12

This chain saw is not suitable for
felling trees. Using the chainsaw for
work other than that for which it is intended
may result in serious injury to the user or
other persons .
Follow all instructions when
clearing jammed material, storing
or servicing the chain saw. Make
sure the switch is off and the
battery pack is removed. Unexpected
actuation of the chain saw while clearing
jammed material or servicing may result in
serious personal injury .
˜ Causes and operator
prevention kickback
Kickback may occur when the nose or tip of the
guide bar touches an object, or when the wood
closes in and pinches the saw chain in the cut .
Tip contact in some cases may cause a sudden
reverse reaction, kicking the guide bar up and
back towards the operator .
Pinching the saw chain along the top of the
guide bar may push the guide bar rapidly back
towards the operator .
Either of these reactions may cause you to lose
control of the saw which could result in serious
personal injury . Do not rely exclusively upon the
safety devices built into your saw . As a chain
saw user, you should take several steps to keep
your cutting jobs free from accident or injury .
Kickback is the result of tool misuse and/or
incorrect operating procedures or conditions
and can be avoided by taking proper
precautions as given below:
Maintain a firm grip, with thumbs
and fingers encircling the chain
saw handles, with both hands on
the saw and position your body
and arm to allow you to resist
kickback forces. Kickback forces can
be controlled by the operator, if proper
precautions are taken . Do not let go of the
chain saw .
14 GB
434668_2304_CZ_SK_HU_SI_02.indb 14 434668_2304_CZ_SK_HU_SI_02.indb 14
Do not overreach and do not
cut above shoulder height. This
helps prevent unintended tip contact and
enables better control of the chain saw in
unexpected situations .
Only use replacement bars
and chains specified by the
manufacturer. Incorrect replacement
bars and chains may cause chain breakage
and/or kickback .
Follow the manufacturer's
sharpening and maintenance
instructions for the saw chain.
Decreasing the depth gauge height can
lead to increased kickback .
˜ Further safety directions
Comply carefully with maintenance, control
and service instructions in this manual .
Damaged protective devices and parts
have to be repaired or changed except as
noted otherwise in this manual .
It is recommended that a first-time user at
least practice the cutting of logs on a saw
log or frame .
For sawing work on hillsides, always stand
in the area above the log . To keep total
control while sawing through, reduce
the pressure at the end of the cut without
loosening your grip on the handles of the
pruning saw . Make sure the saw chain does
not touch the ground . After finishing the
cut, wait until the pruning saw comes to a
stop before removing it there . Always switch
off the motor of the pruning saw before
changing between trees .
Dirt, stones, loose bark, nails, clips and
wires must be removed from the tree .
Do not use any accessories that are
not recommended by PARKSIDE.
This can result in electric shock or fire .
11/3/2023 12:17:24 PM 11/3/2023 12:17:24 PM