Werbung
=
2-SPEAKER SYSTEM
SPEAKER LEAD
White
TO LEFT
SPEAKER
CORD
White w/ Black Stripe
FRONT
Clip
Or*) | zo bert
TO LEFT
Green w/ Black Stripe
(-)
SEEAREH
REAR
;
Gray
Green
TO RIGHT
Gray w/ Black Stripe
(+ ore)
FRONT
TO RIGHT
REAR
violet
TO RIGHT
SPEAKER
Clip
Violet w/ Black Stripe
(-)
4-SPEAKER SYSTEM
® Remove the two clips that are connecting the speaker leads together.
® The Clip can not be removed easily because it is hooked-up. Use a suitable
Plier to release the Hook. See illustration below.
SPEAKER LEAD
SPEAKER CORD
White
(-)
}
(+ or ¢) }
{-)
TO LEFT
FRONT
SPEAKER
TO LEFT
REAR
SPEAKER
TO RIGHT
FRONT
SPEAKER
TO RIGHT
REAR
SPEAKER
(+ or #)
TO LEFT
FRONT
White w/ Black Stripe
TO LEFT
Green
?
REAR
)
_
(
_—_
(+ or ®)
picGigen w/ Black Srp
ceo
ee
(-
Gray
aren.
(+ ore)
TO RIGHT
Gray w/ Black Stripe
FRONT
Violet
Violet w/ Black Stripe
ee
TO RIGHT
REAR
Important instructions for Installation
Attention:
This car radio has a high power amplifier.
Power amplifier of this model is constructed by BTCL (Balanced Transfor-
merless and Condenserless) Circuit.
1. The pilus and minus terminals of the speaker should be connected to the
corresponding plus and minus terminal of this unit. (Fig. A)
Never ground the minus terminal of the speaker to the chassis or body of car.
Never connect the speaker leads as shown in Figs. B and C.
lf a fader equipment (option) is used, the minus terminal of the left channel
must be separated from the minus terminal of the right channel.
PON
2-Speaker and 4-Speaker Selector
The 2-speaker and 4-speaker selector is located on the
rear-side bottom
of the Quick
Release
Bracket @. The
selector is preset at "2-speaker" position in the factory.
Before installing the Quick Release Bracket @, be sure to
set the 2-speaker and 4-speaker selector to the appropriate
position with respect to the speaker system that you are
going to be connected.
CAUTION: NEVER
USE OTHER THAN THE FOLLOWING
SYSTEMS
DESCRIBED
HEREUNIEER.
24
CAUTION: The two clips must not be removed
when
connecting
2-speaker system.
Care-
fully follow the illustration here.
Bottom
@ Quick Release
Bracket
WRONG
SETTING
WILL
CAUSE
FRONT/REAR
FADER
IMBALANCE
AND DISTORTED SOUND.
Werbung
