Werbung
Key Hole
Handle
TY LOCK.
® How to Remove and Install the Unit
REMOVAL:
INSTALLATION:
1. Switch off the power.
Insert and push the unit into its bracket until the back of es-
2. Insert the key into the key hole (Fig. 2,@) completely until
| cutcheon reaches the bracket. The unit will be locked in auto-
~
the safety lock is released.
matically.
As a result, the handle will be slightly lifted upwards. (Fig. 2,
®)
3. Remove the key and lift the handle. Remove the unit from
its bracket by pulling the handle firmly.(Fig. 2, @)
Note:
If the handle is pushed back to its original down posi-
tion, the safety lock will lock on the bracket again. In
this case, repeat step 2 above.
NOTES:
1 Before removing the unit out of its bracket, make sure to
BRACKET
switch off the unit.
key.
a
poe
Werbung
