Intended Use; Product Description - Conrad Mc Crypt MCB-1002 Bedienungsanleitung

Intended Use

This "Mc Crypt MCB-1002" is an audio mixing desk for use in the home or semi-pro-
fessional environments. This appliance can mix low-level audio signals from various
sources of music. The appliance is positioned between the audio signal sources to
be mixed/controlled and an audio amplifier.
The product consists of a mixing desk and a power pack.
The power pack product has been approved for connection to 230 Volt / 50 Hz alter-
nating voltage only. You should only use the adaptor plug supplied or a 9V battery to
power the mixing desk. It may only be used in closed, dry rooms. Contact with moi-
sture must be avoided at all times.
The above described conditions could damage the product and could cause; short-
circuiting, fire and electric shock, etc. No part of the product should be altered or
modified and the housing should not be opened!
The safety instructions should be followed at all times!

Product Description

• Voltage supply via an adaptor plug or battery
• 2 mono inputs, 3 stereo inputs and 2 stereo cinch inputs
• Seperate adjustable input controls on each stereo channel for microphone and
LINE inputs
• INSERT function on mono inputs
• 3-band tone regulation
• Peak indicator for all inputs
• Seperated output regulation for monitor output and FX output
• Phantom power for condenser microphone
• MAIN, monitor and FX output
• 1 stereo output for recording the mixer signal
• Headphone connection
32
Inputs Am- Type
ount
Microphone 5 symmetrical
Mono LINE 2 symmetrical
inputs
Stereo LINE 3 unsymmetrical 2 x. 6,3mm 2 pole. 10 kOhm
inputs
Stereo cinch 2 unsymmetrical 4 x. cinch sockets 10 kOhm
inputs
outputs Am Type
ount
Stereo 1 symmetrical
Master
Output:
FX SEND 1 asymmetrical
MON 1 asymmetrical
REC-OUT 1 asymmetrical
Headphones 1 asymmetrical
XLR socket
(2) Plus + (HOT)
(2) Plus + (HOT)
(1) Ground (GROUND) (1) Masse (GROUND)
(3) Negativ - (Cold)
(2) Negativ - (Cold)
Symmetrical jack plug
Ring = Signal (-)
Shank = Ground Tip = Signal (+)
Asymmetrical jack plug
Shank = Ground Tip = Signal (+)
Connection Input Input
Impedance level
XLR 2 kOhm -60 dB
3-pole 6,3mm 47 kOhm -40 dB
jack socket
-10 dB
jack socket
-10 dB
Connection Output Output
Impedance level
2 x. 3-pole 100 Ohm +10 dB
6.3mm
jack socket
2-pole 6,3mm 75 Ohm +4 dB
jack socket
2-pole 6,3mm 75 Ohm +4 dB
jack socket
4 cinch sockets 1 kOhm -6 dB
3-pole 6,3mm 100 Ohm 3 mW
jack socket 36 Ohm
57