Werbung
OPERATING NOTES
•
Note that the wire may lose tension due to heating. In this case, increase
the tension of the wire.
•
Different materials have different cutting temperatures. Make cutting
tests on a test piece to find the optimum setting.
•
If the cutting temperature is too high, you will notice that the edges
have melted. In this case, reduce the temperature to produce clean cuts.
•
If the cutting temperature is too low, you will have to apply too much
pressure when cutting. The wire will bend and the cut will not be true to
size. In this case, increase the temperature.
•
Using the hot tip: While the hot wire reaches the set temperature after a
few seconds, the hot tip takes longer to heat up. After 2 minutes at the
latest, the hot tip should have reached operating temperature.
•
The hot wire will most likely break close to the clamp. Cut the wire
slightly above the damaged area and re-clamp it.
•
Only use the wire supplied. Other wires have a different electrical
resistance, which can destroy the transformer. Contact our customer
service to reorder heating wire.
•
Clean the heating wire regularly with steel wool or a wire brush so that
no residues can clog the clamping mechanism. Always switch off the unit
and allow it to cool down when working on it.
9
Werbung
