Abus AZ6302 Installations- Und Bedienungsanleitung Seite 77

"Recording and playing a memo"). The "Message" output can still be
used by this function.
When deactivated (OFF), no messages are recorded by the trigger.
8.3.3.7 Messaging options
•
Auto Report
When activated (ON), the GSM dialer automatically dials the programmed
numbers under "Forward Auto Report On" (see "Call Routing") every 24
hours and sends the site message.
When the function is deactivated (OFF), no auto reports are started
(default).
IMPORTANT:
The auto reports must be confirmed using the telephone, otherwise the
number will be dialled again repeatedly!
•
Time Auto Report
Using this function, you can define the time when the auto report is started
(default: 12:00).
Use the
•
Primary TP
Under this menu point you can define the transfer paths used for alarms.
One of the following options can be set:
-
-
-
-
scroll keys to select the desired time.
PSTN Only
Alarm messages are only sent over the analogue telephone
line.
GSM Only
Alarm messages are only sent over the GSM mobile
network.
PSTN first
The GSM dialer attempts to send alarm messages over the
analogue telephone network. If this fails due to a fault, then
the message is sent over the GSM network.
GSM first
The GSM dialer attempts to send alarm messages over the
GSM network. If this fails due to insufficient GSM reception,
then the message is sent over the analogue telephone
network.
77