Switching Outputs - Abus AZ6302 Installations- Und Bedienungsanleitung

Play Restore Message 1-8
Enter Contact Number 1-10
Test Triggers
Play Memo
Record Memo
Cancel Remote Access
IMPORTANT:
The GSM dialer ends the call automatically if no selection is made for 60
seconds following dial-up. If a command is selected, then the device remains
in programming mode for 5 minutes.

11.3.2.1 Switching outputs

Under this menu point, you can switch the outputs 1-4 on and off over the
telephone.
4. Establish a connection to the GSM dialler.
5. Press one of the following keys on the telephone for the
corresponding output:
Output
1
2
3
4
Telephone
key
*11 On: 1 high-pitch tone
Off: 1 low-pitch tone
*12 On: 2 high-pitch tones
Off: 2 low-pitch tones
*13 On: 3 high-pitch tones
Off: 3 low-pitch tones
*14
On: 4 high-pitch tones
96
*5 (then 1-8 for the voice message
number)
*7 (then 1-0 for the contact number)
*8 (then 1-8 for the number)
0
*0 (then 0 or any other key to finish)
#
Tone signal