Starting Hydrogeneration; Switching Off Hydrogeneration; Charging; Charging With Power 24 Batteries - Torqeedo Cruise 3.0 FP TorqLink Originalbetriebsanleitung

8.3.1 Starting hydrogeneration

1. Switch on the Torqeedo system.
2. Set the accelerator lever to the neutral position.
3. Place the emergency stop magnetic chip or connect the kill switch line to
the switch, make sure the emergency stop magnetic chip or kills witch cord
is connected to the skipper.
4. Travel at a speed of at least 4 knots (travel through water, STW).
5. Set the accelerator lever in forward drive to the range 1 - 30 %.
» Hydrogeneration is started.
» "Charging" appears in the display.
» The battery is being charged.
» The charging power generated is shown in the accelerator lever display.

8.3.2 Switching off hydrogeneration

Automatic switch off
Hydrogeneration is automatically switched off when
• the speed over ground (SOG) is below 4 kn for more than 30 seconds or no
positive power is produced.
• the speed over ground (SOG) is above 14 knots for more than 30 seconds.
• the state of charge (SOC) of the battery has reached 100%.
» The "Charging" indicator in the display goes out.
NOTE! Hydrogeneration does not start automatically after switching off. Start
hydrogeneration manually again if necessary.
Manual switch off
1. Set the accelerator lever to the neutral position.
» Hydrogeneration is ended.
» The "Charging" indicator in the display goes out.

8.4 Charging

The charging process of your Torqeedo system differs depending on the
configuration and components used.
The corresponding information can be found in the operating manual for the
respective charger unit.
NOTE! Only use Torqeedo charger units for Torqeedo batteries.
NOTE! To charge the batteries in the boat, a land connection in the boat with
galvanic isolator is required according to applicable national requirements (e.g.
DIN EN ISO 13297, ABYC E-11).
NOTE! Never use mains power cables coiled up to avoid overheating of the
cables.

8.4.1 Charging with Power 24 batteries

Charging
1. Switch on the batteries or the system.
2. Plug in the charger unit.
3. The charging process starts automatically.
4. "Charging" is shown in the display.
5. Fully charge the batteries.
Ending charging
1. Unplug the charger unit.
2. Switch off the system or the battery.

8.4.2 Charging with Power 48 batteries

Charging
1. Switch off the Torqeedo system.
2. Plug in the charger unit.
3. The charging process starts automatically.
4. "Charging" is shown in the display.
5. Fully charge the batteries.
DE EN
77