Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
Move the accelerator lever to the neutral position to stop the motor.
»
To continue travelling, you can simply give forwards/reverse motion again.
•
Pull off the emergency stop magnetic chip to stop the motor.
»
To continue travelling, replace the emergency stop magnetic chip.
»
Set the accelerator lever to the neutral position.
NOTE! Pressing the emergency skill switch or pulling the kill switch cord
switches the system off. To put it back into operation, it must be restarted.
NOTE! Do not use the emergency kill switch or pull the kill switch line cord
switch off the system regularly if there is no emergency situation.
•
Press the emergency kill switch or pull the kill switch cord.
»
To continue travelling, reset the emergency kill switch or reinsert the kill
switch cord.
»
Set the accelerator lever to the neutral position.
»
Start the Torqeedo system.
•
Set the battery main switch to the "OFF" position to switch off the system.
»
To continue the journey, put the accelerator lever into the neutral position.
»
Reset the emergency kill switch or insert the kill switch cord (if present).
»
Set the battery main switch to the ON position.
»
Start the Torqeedo system.
»
Insert the emergency stop magnetic chip (if present).
8.2 Operation
8.2.1 Before travelling
Observe the following points before each use of your Torqeedo system to ensure
a safe trip.
•
Familiarise yourself with the travel area before setting off, as the range
shown in the onboard computer does not take into account wind, current
and direction of travel, and plan a sufficient buffer for the required range.
•
If there is visible damage to components or cables, the Cruise system must
not be switched on.
•
Ensure that everyone on board is wearing a lifejacket.
•
Attach the emergency stop magnetic pin lanyard or kill switch cord to the
skipper's wrist or lifejacket before launching.
•
The battery state of charge must be checked at all times while on the move.
•
Only apply the emergency stop magnetic chip or the kill switch cord when
there are no more people in the water (e.g. after bathing breaks), or remove
it immediately if people fall into the water to stop the drive.
•
Also observe all information from the "Safety" and "Before use" sections.
8.2.2 Switching on/off (Cruise 6.0 FP TorqLink only)
Switch on
1.
Set the battery main switch to the ON position.
2.
Depending on the configuration, press the "ON/OFF" button or operate the
key switch to switch on the system.
Switch off the system and batteries
1.
Depending on the configuration, press the "ON/OFF" button or operate the
key switch to switch off the system.
»
The system shuts down.
»
The battery is switched off, only a very small self-discharge takes place.
2.
Set the battery main switch to the off position.
8.2.3 Switching on/off (Cruise 3.0 FP only)
Switch on
1.
Set the battery main switch to the ON position.
2.
Depending on the configuration, press the "ON/OFF" button or operate the
key switch to switch on the system.
Switch off the system and batteries
NOTE! Power 24-3500 batteries cannot be switched off manually without the
additional on/off switch for Power 24-3500.
1.
Depending on the configuration, press the "ON/OFF" button or operate the
key switch to switch off the system.
»
The system shuts down, the battery remains switched on.
2.
Set the battery main switch to the off position.
3.
The battery switches off automatically after 48 hours if it is not used.
DE
EN
75
Werbung
Inhaltsverzeichnis
Fehlerbehebung
