Propeller - Torqeedo Cruise 3.0 FP TorqLink Originalbetriebsanleitung

DE EN

10.4.4 Propeller

NOTE! If the maximum speed of the boat exceeds 14 knots through the water
(STW), the optional folding propeller must be used to avoid damage to the motor
caused by excessive propeller rotational speeds
Danger of injury or death from rotating propeller. This can result in sever
injuries or death.
• Switch off the system at the battery main switch and secure it against
being switched on again by pulling off the switch handle to prevent the
propeller from starting.
Checking
1. Switch off the system at the battery main switch and secure it against being
switched on again by pulling off the switch handle.
2. Check the propeller for damage such as cracks, chipping and deformation.
3. Check the gap between the pylon and the propeller for foreign objects, e.g.
fishing lines, seaweed, etc. Wear gloves when doing this to avoid injury.
4. Dismantle the propeller to remove any contamination.
Disassembly
2
1
4
TIP! Remove the propeller when the motor is attached to the boat and the boat is
safely on land.
1. Ensure that the motor is securely fastened and secured against falling
82
DANGER
3
5
(e.g. e.g. on the boat or on a workbench).
2. Remove the galvanic anode (1).
3. Loosen the lock nut (2) with a socket wrench SW17 and unscrew it from the
motor shaft (3).
4. Remove the washer (4).
NOTE! Component damage due to incorrect tool. Do not use force or tools such
as hammers to remove the propeller.
5. Pull the propeller off the motor shaft, move the propeller in different
directions to make it easier to pull off.
6. Remove the thrust washer (5).
7. Clean the motor shaft.
8. Clean the thread of the motor shaft.
Installation
4
5
3
1. Position the thrust washer (1) on the motor shaft (2).
2. Position the propeller on the motor shaft, noting the installation direction.
3. Position the washer (3) on the motor shaft.
NOTE! Component damage due to thread locking varnish. Do not use locking
varnishes or additives.
4. Screw the lock nut SW17 (4) onto the motor shaft and tighten it.
• Lock nut: 11+/- 1 Nm, 97+/-1 in-lbs
5. Install the galvanic anode (5).
2
1