Stiga 9L3BL Bedienungsanleitung Seite 110

EN
"Blackout"
on the display
"Wheel error" appe-
ars on the display
"Bump Error" appe-
ars on the display
"Safety Lift" appears
on the display
User's manual
Interruption of the
power supply to the
transmitter
Overheated power
supply un
appears
Presence of other
installations nearby
Perimeter wire
oxidised caused by
damage to the pro-
tective sheathing.
Ground is uneven or
contains obstacles
that prevent move-
ment
Failure of one or both
motors that operate
the transmission of
the wheels.
The bumper sensors
are blocked
Front body sensor
does not work
Restart the robot
Adopt the appropriate measures to reduce
the temperature of the power supply unit
(ventilate or modify the installation area, etc.)
(see "Planning of plant installation")
Contact an authorised Service Centre
Contact your nearest authorised service
centre to check the impedance (Ohm) of the
perimeter wire
Make sure the lawn to mow is even and does
not contain holes, stones or other obstacles.
Otherwise, fi ll in any holes and remove any
obstacles (see "Preparation and marking the
boundaries of the work areas (primary and
secondary areas)")
Have the motor replaced or repaired by your
nearest authorised service centre
Remove the hood and check
the functionality of the sensors
Makes sure the upper body is positioned
correctly. If the problem persists, contact
your nearest authorised service centre
52