Balluff BOS R254K-UUI-RE10-S4 Konfiguration Seite 174

BOS R254K-UUI-RE10-S4
Photoelectric Sensors
5
Secondary Device Functions (continued)
5.9.5 System Commands
Command Value Device Action
0x81 (129) Application Reset – Resets the
Voltage monitoring detection time
duration with ISDU-index 0x58
Sub index 2 to the default value 0.
0x82 (130) Reset Factory Settings – Resets the
Voltage monitoring detection time
duration with ISDU-index 0x58
Sub index 2 to the default value 0.
0xA5 (165) Maintenance Reset – Resets the
Voltage monitoring detection time
duration with ISDU-index 0x58
Sub index 2 to the default value 0.
Tab. 5-45: Voltage and current monitoring – System Commands
For an overview of all System Commands, see section 3.5
on page 21.
5.9.6 Events
Event Code Event Type
0x5110 Warning
(20752)
0x5111 Warning
(20753)
0x8D0B Warning
(36107)
0x8D0D Warning
(36109)
0x8D15 Warning
(36117)
Tab. 5-46: Voltage and current monitoring – Events
70 english
Description
Primary supply voltage exceeded
► Check for deviations in the supply.
Primary supply voltage below minimum value
► Check for deviations in the supply.
Overload or short circuit at pin 2
► Check wiring.
Incorrect load/cable breakage, analog current output pin 2
► Check wiring or connected devices.
Overload at pin 2
► Check wiring.
Device Status
2 – Out-of-Specification
2 – Out-of-Specification
2 – Out-of-Specification
2 – Out-of-Specification
2 – Out-of-Specification