Balluff BOS R254K-UUI-RE10-S4 Konfiguration Seite 195

BOS R254K-UUI-RE10-S4
Photoelectric Sensors
6
System Functions (continued)
Value Name
Analog Output
0x0006 (6) Switching Counter Value
0x0013 (19) Switching Speed Value
0x001B (27) Current Operating Hours
0x001C (28) Total Operating Hours
0x001D (29) Custom Operating Hours
0x001E (30) Boot Cycle Counter
0x001F (31) Custom Boot Cycle Counter
0x0020 (32) Current Signal Quality
0x0035 (53) Contamination level
0x0036 (54) Inclination Deviation Value
0x0042 (66) Lifetime Extreme Time
0x004A (74) Vibration Level
0x0050 (80) Device Temperature
0x0053 (83) Minimum
0x0054 (84) Maximum
0x0055 (85) Average
0x0056 (86) Moving Average
0xFFF7 (65527) Transducer Signal
Tab. 6-14: Pin assignment – Signal Source
Logic
With Logic, the input/output can be configured as inverted
or normal.
Value Name Description
0x00 (0) Normal Non-inverted logic
0x01 (1) Inverted Inverted logic
Tab. 6-15: Pin assignment – Logic
Characteristic
With Characteristic, a rising or falling characteristic of the
analog output can be configured.
Value Name Description
0x00 (0) Rising Rising input value = Rising
output value
0x01 (1) Falling Rising input value = Falling
output value
Tab. 6-16: Pin assignment – characteristic
www.balluff.com
Type
The output can be configured with Type.
Value Name Description
Digital
0x00 (0) PNP PNP output
0x01 (1) NPN NPN output
0x02 (2) Push-Pull Push-Pull output
Analog
0x00 (0) 4...20mA Analog current output 4 to
20mA
Tab. 6-17: Pin assignment – Type
6.5.3 System Commands
For an overview of all System Commands, see section 3.5
on page 21.
english 91