Herunterladen Inhalt Inhalt Diese Seite drucken

Initial Activities; Sanding Belt Placing; Shifting The Base Operation Board (Grinding Support) By Height; Shifting Of The Base Operation Board (Grinding Support) Transversally - HOLZMANN-MASCHINEN KOS 3000C Originalbetriebsanleitung

Oszillierende kantenschleifmaschine
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

¡ERROR! UTILICE LA PESTAÑA INICIO PARA APLICAR ÜBERSCHRIFT 1 AL TEXTO QUE DESEA QUE
14.2

Initial activities

14.2.1 Sanding belt placing

14.2.2 Shifting the base operation board (grinding support) by height

Loosen the tightening handle F (fig. 6), placed at the right of the hand wheel H;
Shift the grinding base G in the desired direction by means of the hand wheel H;
Tighten the handle F.

14.2.3 Shifting of the base operation board (grinding support) transversally

Loosen the tightening handle P (fig. 6), placed under the base board;
Push or pull the base board in the desired direction;
Tighten the handle P.
Take care to avoid striking the base board to the grinding catches I and J.

14.2.4 Tilting of grinding device

Loosen the tightening handle K (fig. 6), situated at the left side of machine's support;
Tilt the grinding device in the desired degree, reading by ruler Q, by means of the left
hand wheel L;
Tighten the handle К.

14.2.5 Adjusting for grinding the veneered edges

For this is necessary to mounting the device for grinding the veneered edges in following way:
Pull completely the grinding support G (fig. 6).
Loosen band pulling device by means of the lever.
Insert the grinding shoe C (fig.7) with the supporting rolls between the grinding band and
the casing of the flat grinding unit in holes A and tighten the handle B. The position of the
HOLZMANN MASCHINEN Austria
All manuals and user guides at all-guides.com
www.holzmann-maschinen.at
OSZILLIERENDE KANTENSCHLEIFMASCHINE / OSCILLATING EDGE BELT SANDER
• Open or remove the covers /fig. 6, А,
B, C and D/ of the grinding band;
• Loosen the pulling device of the band
through the lever;
• Open the two grinding catches J and I
and put the new grinding band;
• Follow the direction of rotation
indicated by the arrow on the reverse
side of the sandpaper;
• Unlock and close the two grinding
supports J and I. Avoid squeezing the
grinding band;
• Pull slowly the band;
• Switch on machine for a short time and
control the motion of the sanding belt
by the screw Е on the leading (free)
roll. The grinding band must run
through the middle part of the free roll;
• Close or assemble back the covers on
the grinding band.
APAREZCA AQUÍ.
A
Seite 38
KOS 3000C

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis