Mounting / Dismounting, Operating Position - Stahl 9176-Serie Betriebsanleitung

Mounting and Installation
EN
8.2

Mounting / Dismounting, Operating Position

EN
EN
8.2.1 Mounting / Dismounting of the Device on Top Hat Rail and pac-Bus
Mounting on top hat rail
EN
EN
EN
EN
EN
EN
EN
EN
EN
Mounting on pac-Bus
EN
EN
EN
EN
EN
EN
EN
Dismounting
EN
EN
EN
EN
EN
EN
8.2.2 Mounting / Dismounting on pac-Carrier
Mounting
16
Binary Output without Power Supply
Series 9176
• Position the device on the top hat rail.
Position the cut-out of the enclosure on the outside edge
of the top hat rail.
• Engage the device on the top hat rail.
• When swivelling the device onto the top hat rail,
make sure that it is not set at an angle.
06886E00
The pac-Bus is equipped with a polarisation guide and the
device with a matching slot.
• Position the device as shown in the illustration.
Position the cut-out of the enclosure on the outside edge
of the top hat rail.
15554E00
• Engage the device on the pac-Bus.
• Pull out the base bolt somewhat using a screwdriver.
• Swivel out the device.
06881E00
• Remove the black and green terminals.
• For single-channel devices: remove the covering in
terminal slot 2 (between the black and the green
terminal).
12613E00
222196 / 9176611310
2021‐07‐16·BA00·III·en·09