Installation - Stahl 9176-Serie Betriebsanleitung

Dismounting
8.2.3 Mounting / Dismounting pluggable Terminals
All devices are equipped with pluggable terminals.
Mounting
• Plug the terminal into the device until the terminal engages.
Dismounting
8.3

Installation

Operation under difficult conditions, such as, in particular, on ships,
requires additional measures to be taken for correct installation, depending
on the place of use. Further information and instructions on this can be
obtained from your regional sales contact on request.
222196 / 9176611310
2021‐07‐16·BA00·III·en·09
• Position the device on the pac-Carrier. Place the cut-out
of the enclosure on the outside edge of the pac-Carrier.
• When pivoting the device onto the pac-Carrier,
make sure that it is not set at an angle.
• Swivel in the device up to the red notch lever.
• Close red notch lever by applying diagonal pressure on
the lever with the thumb until the lever engages audibly at
the device.
15569E00
• Ensure that the red notch lever is engaged.
• Swivel out the notch lever using a screwdriver.
• Swivel device out of the slot.
15574E00
• Position the screwdriver behind the terminal.
• Push out the terminal.
10859E00
Mounting and Installation
Binary Output without Power Supply
Series 9176
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
17