Function and Device Design
EN
• When used in Zones 2, the intrinsically safe devices of Zones 1, 0, 21 and 20 can be
EN
connected to the intrinsically safe signal circuits.
• If used in Zone 2, the device must be installed in an enclosure that meets the
EN
requirements of IEC/EN 60079-15.
EN
• Connect the device only to intrinsically safe terminals.
• The safety characteristic values of the connected field devices must correspond to the
EN
specifications in the data sheet or in the EC Type Examination Certificate.
EN
Maintenance, repair, commissioning
EN
• Before commissioning, make sure that the device is not damaged.
EN
• Work on the device, such as installation, maintenance, overhaul, repair, may only be
EN
carried out by appropriately authorised and trained personnel.
• Perform only maintenance work or repair described in these operating instructions.
EN
• Only use the device up to SIL 3 (IEC 61508).
EN
EN
3.3
Modifications and Alterations
EN
EN
EN
EN
EN
EN
EN
EN
EN
4
Function and Device Design
EN
EN
EN
EN
4.1
Function
Application range
For example, binary outputs without auxiliary power are used for intrinsically safe
operation of solenoid valves or LED indicator lamps.
Mode of operation
The devices do not require a separate power supply, but are instead supplied via the
triggering output.
6
Binary Output without Power Supply
Series 9176
Explosion hazard due to modifications and alterations to the device!
Non-compliance results in severe or fatal injuries.
• Do not modify or alter the device.
No liability or warranty for damage resulting from modifications and
alterations.
Explosion hazard due to improper use!
Non-compliance results in severe or fatal injuries.
• Use the device only in accordance with the operating conditions
described in these operating instructions.
• Use the device only for the intended purpose specified in these
operating instructions.
DANGER
DANGER
222196 / 9176611310
2021‐07‐16·BA00·III·en·09