Mounting / Dismounting, Operating Position - Stahl 9175-Serie Betriebsanleitung

8.2

Mounting / dismounting, operating position

8.2.1 Mounting / dismounting pac-Bus
The pac-Bus is an accessory which facilitates wiring of the auxiliary power and reading
out of the collective error message.
The components for the pac-Bus Type 9194 must be ordered separately.
Mounting
Dismounting
• Proceed in the reverse order to mounting.
8.2.2 Mounting / dismounting of the device on top hat rail and pac-Bus
Mounting on top hat rail
Mounting on pac-Bus
160428 / 9175601310
2016-02-02·BA00·III·en·06
• Connect the required number of pac-Bus elements.
07392E00
• Engage the pac-Bus elements on the top hat rail.
07391E00
• Connect the terminal set at the beginning and at the end.
15551E00
• Position the device on the top hat rail. Position the cut-out
of the enclosure on the outside edge of the top hat rail.
• Engage the device on the top hat rail.
• When swivelling the device onto the top hat rail, make
sure that it is not set at an angle.
06886E00
The pac-Bus is equipped with a polarisation guide and the de-
vice with a matching slot.
• Position the device as shown in the illustration. Position
the cut-out of the enclosure on the outside edge of the top
hat rail.
15554E00
• Engage the device on the pac-Bus.
Mounting and installation
Binary Output
Series 9175
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
15