Transport And Storage; Mounting And Installation; Dimensions / Fastening Dimensions; Mounting / Dismounting, Operating Position - Stahl 8162 Serie Betriebsanleitung

Technical Data
Material
Breather
Locknut
Thread size
Tightening torque
Mounting
For further technical data, see www.stahl-ex.com
6

Transport and storage

• Transport and store the device only in the original packaging.
• Store the device in a dry place (no condensation) and vibration-free.
• Do not drop the device.
7

Mounting and installation

7.1

Dimensions / fastening dimensions

Dimensional Drawings (All Dimensions in mm) - Subject to Alterations
SW 29 SW 30
2
9
14,50
37
7.2

Mounting / dismounting, operating position

• For the operating position refer to the attached documentation.
When mounting the breather, make sure to do the following:
• Only insert the breather into the through hole of the enclosure wall.
Maximum thickness of the enclosure wall: 1 to 5 mm.
• Secure the breather using the locknut: screw the locknut onto the breather and tighten
it. Observe the specified tightening torque! Make sure that the flat seal is fitted correctly
and is not twisted!
138591 / 8162601300
2015-10-14·BA00·III·en·06
polyamide
polyamide
M25 x 1.5
( 4 Nm (nut)
only permitted in enclosures with through hole
.
Transport and storage
Breather
Series 8162
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
12061E00
7