Status Codes - Bosch Rexroth PSI 6xCx.727 Typspezifische Anleitung

R911336188 | PSI 6xCx.727
8

Status codes

In case of a general fault, the status code is on the output. In case of a welding
fault, the additional code with an offset 1000 is on the output.
Tab. 10: Status codes
Code (decimal) Meaning
00 OK
80 Stop / no 24V
81 Weld without command
84 Battery fault
85 Memory deleted == RAM checksum error
86 Data download started
87 No schedule programmed == invalid parameters
88 Hardware fault
89 Serial I/O bus fault (only for timers with a serial I/O bus)
90 Half-cycle monitoring
91 Circuit breaker tripped
92 External over-temperature
93 Synchronization fault
94 Start inhibited
95 Program parity error
98 Programmed value too high
100 Supply voltage fault
115 PSQ fault
160 Heat sink temperature too high
164 Transformer temperature too high
165 Hardware fault driver module
166 24V supply voltage fault
1001 Current measurement circuit open
1002 Current measurement circuit shorted
1003 No primary voltage 1.HW
1004 Primary voltage measuring fault
1005 Reweld by timer active
1006 Inhibit monitoring mode active
1007 Ignition turned off during schedule
1008 KSR block ON - active
1010 No current (standard mode)
1011 No current PreWLD (mixed mode)
1012 No current MainWLD (mixed mode)
1013 No current PstWLD (mixed mode)
Bosch Rexroth AG 43/47
Status codes