7.1.11 Supervision Of Minimum Current; Status Codes - Bosch Rexroth PRC 7 00-L /W 403 Serie Typspezifische Anleitung

R911381576 | PRC 7x00-Lx/Wx-403 Bosch Rexroth AG | Electric Drives and Controls
After reset of error the output "magnet valve (water flow)" will be switched on
again.

7.1.11 Supervision of minimum current

The time within which the current has to exceed a minimum threshold is
adjustable. If this threshold is not exceeded on average, the sequence is stopped
and an error message occurs.
8

Status codes

Tab.10: Status codes
Code (decimal) Meaning
0 No error
10000 PLC - Module call with wrong data type
10001 PLC - Module can not find data element
10002 PLC - Abo still not active
10003 PLC - Abo not exists
10004 PLC - Abo exists already
10005 PLC - IPC error
10006 PLC - Timeout
10007 PLC - Spot selection has been changed unlicensed
10008 PLC - Selected spot is not existing
10009 PLC - Tip dress aborted with error
10010 PLC - Tip change aborted with error
10011 PLC - Gun change aborted with error
10012 PLC - Tip dresser change aborted with error
12000 Tip dresser changed
12001 Tip dresser in prewarnung
12002 Tipdresser at end of life
13000 Electrode dressed
13001 Electrode changed
13002 Gun component changed
13003 Gun mechanics
13004 Electrode has to be dressed
13005 Elektrode has to be replaced
13006 Gun component in prewarning
13007 Gun component at end of life
14000 Movement aborted
14001 Unknown command
41/47