Lifting The Suprasetter Off The Pallet - HEIDELBERG Suprasetter A106 Installationsanleitung

Installation
Fig. 9 Rear panels
Fig. 10 Cover and cover plate

Lifting the Suprasetter off the Pallet

Fig. 11 Transport brackets
Note: Unscrew rollers
The rollers must be unscrewed from the lifting rods before the lifting rods are pushed in! If
this is not done, the lifting rods cannot be inserted far enough into the bushing on the chas-
sis and cannot be secured.
42
Loosen the three clips (Fig. 9/1) in the upper rear
panel by 1/4 turn and take off the rear panel.
Loosen the three clips (Fig. 9/2) in the lower rear
panel
by1/4 turn and take off the rear panel.
Fig. 9 shows a semi-automatic version. The upper
rear panel is closed on a stand-alone version, an
autoloader version does not have an upper rear
panel.
Loosen three screws (Fig. 10/3) on each side of the
cover plate and take off the cover plate.
Loosen two screws (Fig. 10/2) on both sides of the
cover and four screws (Fig. 10/1) at the rear and lift
off the cover.
Loosen four transport brackets.