Belt Back Stop; Installing Dust Collection; Operation; Operation Instructions - HOLZMANN-MASCHINEN BT 150-914 Betriebsanleitung

Attention! To prevent fingers from being
squeezed between the band and table a
minimum separation of 1.6 mm has to
be maintained between the table and
sanding band.

13.2 Belt back stop

The belt backstop prevents the workpiece from being pulled or dragged beyond the sanding belt surface. It
should always be used to help control the workpiece when using the sanding belt.
Loosen the inner hex screw (1) using the
5 mm hex key, and raise the belt bed (2)
in the 90 degree vertical position. Tighten
the inner hex screw (1).
Place the belt back stop (3) onto the sander
frame, aligning the slot (4) on the belt back
stop with the threaded hole (5).
Insert two screws (6) through the slot (4)
and tighten into threaded hole (5) with the 5
mm hex key.

13.3 Installing dust collection

The use of a dust collection system with the sander is strongly recommended.
The sander has two dust ports (1xDisc, 1xBelt). Slide the hose of your dust collector over the outlet, and
secure with a hose clamp (not in the delivery content).
14

OPERATION

Device to be operated in a perfect state only. Inspect the device visually every time it is to be used.
Check in particular the safety equipment, electrical controls, electric cables and screwed connection
for damage and if tightened properly. Replace any damaged parts before operating the device.
14.1

Operation instructions

Perform all machine settings with the machine being
Please observe the following operating instructions so that their work
can be performed safely and has the expected success.
HOLZMANN MASCHINEN GmbH
WARNING
disconnected from the power supply!
www.holzmann-maschinen.at
ATTENTION
NOTICE
OPERATION
24
BT150-914