Miter Gauge; Horizontally / Vertikally Operation Of Belt Sander; Disc-Sanding; Belt-Sanding - HOLZMANN-MASCHINEN BT 150-914 Betriebsanleitung

14.3.2

Miter gauge

A miter gauge (1) is supplied with your sander and can be used
with the sanding table. The miter gauge body can be adjusted
from 0° to 60° right or left for angle or miter sanding.
1. Install the miter gauge bar (2) into the table slot (3) as shown.
2. Loosen lock knob (4), rotate miter gauge body to the desired angle.
3. Tighten lock knob (4).
14.3.3

Horizontally / vertikally operation of belt sander

Your belt/disc sander - belt station can sand vertically as well as
horizontally. Depending on operator needs and the workpiece, the
Sanding table can be used with either the horizontal or vertical position.
To change from one position to the other:
1. Loosen the inner hex screw (1) by turning it counter clockwise with
the 5 mm hex key.
2. Manually move the work support station into the vertical or
horizontal position, as required.
3. Retighten the inner hex

14.3.1 Disc-Sanding

When sanding, always position your work on the
downward, rotating side (left side) of the sanding
disc. The sanding action will then force the wood
down, safely towards the table, where it can be
controlled. Sanding on the right, upward rotating
side of the disc is dangerous, as your work cannot be
controlled and 'kick-back' may occur - the wood
being forced up and out of your hands.

14.3.1 Belt-sanding

1. Hold the work piece firmly, keeping fingers away
from the sanding belt (3).
2. Keep the work piece (2) against the backstop
/sanding table and move it evenly across the sanding
belt. Use extra caution when sanding very thin
pieces.
3. Do not force the work piece into the sanding belt.
Sand using light pressure, letting the sanding
abrasives time to do their work!
4. Move your work piece slightly left and right on the
belt. This will help prevent resin or debris from
building up on one area of the belt, and also helps to
prevent burning of the sanded surface from
excessive abrasive-action heat build-up.
SANDING CURVED EDGES
Sanding inside curves on your work piece and be
done on the idler drum (4) as shown.
15

MAINTENANCE

HOLZMANN MASCHINEN GmbH
ATTENTION
www.holzmann-maschinen.at
4
26
BT150-914