Winter Use; Working With The High-Pressure Cleaner (Ex-Factory Option) - Kärcher MC 130 Plus Bedienungsanleitung

The vehicle can only be moved at a limited speed.
Manual regeneration - stage 4
This type of regeneration can only be performed by service per-
sonnel. Automatic regeneration and "Parked regeneration" are
disabled. The vehicle can only be moved forward at a limited
speed.
A warning symbol is visible on the display.
Manual regeneration - stage 5
Regeneration is no longer possible. A corresponding warning
should be displayed in large format. "Parked regeneration" and
automatic regeneration are disabled.
The vehicle can only be moved forward at a limited speed.
Parked regeneration
"Parked regeneration" can only be performed when the following
requirements are met:
● Travel direction position: Neutral
● Parking brake active
● Engine control unit does not display any error codes
● Accelerator not actuated
Manual regeneration can be activated when these requirements
are met.
The parked regeneration process takes approx. 30 minutes.
The seat cannot be vacated!
Start regeneration
WARNING
Risk of burns
During the regeneration process, exhaust gases up to a temper-
ature of 600°C may be omitted.
Do not start the regeneration process in combustible areas.
Note
Only interrupt the regeneration process in the case of an emer-
gency.
Note
If the regeneration indicator on the display lights up during oper-
ation then a regeneration process must be started.
Regeneration can be performed automatically or manually.
Work can continue during Automatic regeneration.
1. For manual cleaning ("Parked regeneration"), stop at suitable
location within 15 minutes.
Regeneration duration is approx. 30 minutes.
2. Set the travel direction to the NEUTRAL position and do not
press the accelerator pedal.
The driver's seat can be vacated during this period.
3. To start the regeneration process, first press function key F 10
(lower right key), then press F 1 for Automatic or F 2 for Man-
ual cleaning.
Note
The engine speed increases noticeably during both types of
cleaning. When cleaning has finished the indicator lamp goes out
and the engine speed decreases again.
Note
The regeneration instructions above should suffice in most cases
and more detailed descriptions are provided in the section "Faults
with display".
1. Ensure there is enough antifreeze in the coolant.
During winter use, the sweeping system and suction mouth must
be disassembled and placed into storage.
Working with the high-pressure cleaner (ex-factory
Use the high-pressure cleaner only for the following activities:
● Cleaning with the high-pressure jet without detergent (e.g.
façades, park seats, garden paths).
● Only operate the high-pressure cleaner with the flat jet nozzle
provided.
● This high-pressure cleaner is intended and tested for the ex-
clusive use with the sweeper vacuum MC 130.
Pressure relief valve
When the water quantity is reduced via the pressure/quantity
control on the trigger gun, the overflow valve opens and part of
the water flows back to the suction side of the pump.
Safety valve
The safety valve opens when the permissible operating pressure
is exceeded and the water flows back to the suction side of the
pump.
Trigger gun
1
Pressure and quantity regulation
2
Spray lance
3
High-pressure hose connection
4
Nozzle holder
5
High-pressure hose storage compartment
6
English

Winter use

Frost protection
Sweeping system
option)
Intended use
Device elements
83