Online Processor; Connecting The Online Processor To The Suprasetter - HEIDELBERG Suprasetter 106 Installation

Installation
The
Instructions for Testing
When adjusting the laser modules, take note of the information in the service
manual, Laser module adjustment chapter.

Online Processor

Connecting the Online Processor to the Suprasetter

Fig. 86 Connection point for bonding
Note: Adjust the online processor height such that a plate being transported into the online
processor does not get caught..
Sensitive electronics
Make sure to deenergize the Suprasetter as well as the online processor prior to
connecting any cables..
90
chapter in the service manual describes how to test printing plates.
NOTICE
Connect the equipotential bonding cable for the
online processor to one of the two mass points
(Fig. 86/1) in the Suprasetter.
NOTICE