Configuring A Panel For The Steering Position Where The Panel Is Placed - Vetus ELINE050 Einbauanleitung Und Bedienungshandbuch

8 .7 Configuring a panel for the steering position
where the panel is placed
Carry out the following actions on EACH panel in the order indi-
cated:
N.B. The panel must be in the OFF position (if the panel is NOT in the
OFF position, first long press the "ON/OFF" button to turn the panel
to the OFF position.
1
2
10 seconds
2. Place the panel in configuration mode.
• Press and hold the 'ON/OFF' button for 10 seconds.
3
didahdi ( . − . )
4
OR
Helm station
1 2 3 4
4. Select the steering position where the panel is located by moving the lever momentarily from neutral to
the left or right and back again. The color and the flashing of the LED indicate the number of the helm
position.
For a port and starboard panel, together on a helm station, the
set helm station number must be the same .
vetus® Installation instructions and operation manual E-Line electric propulsion
1. Move the lever to the right.
dididididididid ( . . . . . . )
6 seconds
3. Press the 'ON/OFF' button to
confirm. Now the panel is in
configuration mode.
Helm station
1 2 3 4
n
ote
3
dididididah ( . . . . − )
Con guration mode
4 seconds
During the first 6 seconds, the buzzer will continuously signal a did-
ididididi ..... (. . . .). Keep pressing the On / Off button. After 10 seconds
the buzzer sounds the signal dididididah (. . . - -).
1 BLUE, ashing
2 RED, ashing
3 BLUE, ashing
RED, quick ashing
4 BLUE and RED,
simultaneously ashing
Settings are retained when the power supply is switched off!
ENGLISH
2
1
5
1 x
5. Press the 'ON/OFF' button
once to confirm the setting.
n
ote
370301.01
33