Configure A Panel To Operate A Port Or Starboard E-Line Motor - Vetus ELINE050 Einbauanleitung Und Bedienungshandbuch

8 .6 Configure a panel to operate a port or star-
board E-Line motor
Carry out the following actions on EACH panel in the order indi-
cated:
N.B. The panel must be in the OFF position (if the panel is NOT in the
OFF position, first long press the "ON/OFF" button to turn the panel
to the OFF position.
1
2
10 seconds
2. Place the panel in configuration mode.
• Press and hold the 'ON/OFF' button for 10 seconds.
3
1 x
4
1 x
BLUE
4. Configuring for a port side motor: Move the lever to the left once. The 'ON/OFF' button
LED lights up blue.
Configuring for starboard motor: Move the lever to the right once. The 'ON/OFF' button
LED lights up red.
For a port and starboard panel, together on a helm station, the
set helm station number must be the same .
32
370301.01
1. Move the lever to the left.
dididididididid ( . . . . . . )
6 seconds
3. Press the 'ON/OFF' button to
confirm. Now the panel is in
configuration mode.
RED
n
ote
As delivered, the panel is configured for a port side motor .
4 seconds
During the first 6 seconds, the buzzer will continuously signal a did-
ididididi ..... (. . . .). Keep pressing the On / Off button. After 10 seconds
the buzzer sounds the signal dididididah (. . . - -).
1 x
Settings are retained when the power supply is switched off!
vetus® Installation instructions and operation manual E-Line electric propulsion
1 2
n
ote
dididididah ( . . . . − )
Con guration mode
5
1 x
5. Press the 'ON/OFF' button once to confirm
the setting.
n
ote