Herunterladen Inhalt Inhalt Diese Seite drucken

Edge Banding (Straight Edge Mode); Edge Banding (Radius „S" Mode) - HOLZMANN-MASCHINEN KAM 535 Betriebsanleitung

Kantenanleimmaschine
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

15.2.6

Edge banding (Straight edge mode)

Checklist before start:
Edge band inserted and height adjusted
Glue granules filled.
Machine is switched on (main switch on "I").
Glue target temperature reached.
Feed motor activated (control lamp feed lights up)
Speed Feed motor selected and motor activated.
Mode selector switch to "Straight".
Glueing process:
Place the workpiece to the right of the limit switch at the stop.
Push the workpiece to the left and when the limit switch is actuated, the edge feed is
started automatically and the edgeband is fed at the selected speed.
Push the workpiece evenly, with a short overhang of the edge band at the beginning of the
workpiece, together with the edge band to the left.
Press the workpiece evenly against the rubber rollers.
As soon as the workpiece is no longer in contact with the limit switch (end of workpiece
reached) the edgeband is cut with the cutting knife and the feed is stopped (pressure roll-
er and thus edgeband is removed from the drive wheel - no power transmission to the
edgeband).
After this process, another edge of the workpiece can be glued or machine stopped.
15.2.7
Edge banding (Radius „S" mode)
Checklist before start.
Edge band inserted and height adjusted
Glue granules filled.
Machine is switched on (main switch on "I").
Glue target temperature reached.
Feed motor activated (control lamp feed lights up)
Speed Feed motor selected and motor activated.
Mode selector switch to Radius"S".
Pressure rollers/workpiece support disassembled
Adjusting the timer for edge band length.
Glueing process:
Place the workpiece against the stop.
Press the foot pedal to start the edge feed automatically and feed the edge band at the se-
lected speed.
Push the workpiece evenly, with a short overhang of the edge band at the beginning of the
workpiece, together with the edge band to the left in the given workpiece shape.
After this process, another edge of the workpiece can be glued or the machine stopped.
HOLZMANN MASCHINEN GmbH
www.holzmann-maschinen.at
If necessary, depending on the type of work-
piece to be machined, the pressure rollers (1
and/or 2) and part of the workpiece support (3)
must be removed. To do this, remove the
screws (S) and then the components from the
machine.
The timer can be set using the buttons, after
activating the feed the timer counts down (indi-
cated on the display). At 0 the edge is cut off
and feed is stopped.
OPERATION
30
KAM535

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis