Digital Cooking Programmer - Franke MARIS FREE MA 82M F Serie Installations- Und Gebrauchsanweisung

Note: The oven stays hot at around the set
cooking temperature for a long time after
it has been switched off; therefore to avoid
overcooking or burning the food, it is advisable
to remove it from the oven.
Note: To use the oven in manual mode,
i.e. without using the end of cooking timer, align
the knob (B) pointer with the fixed symbol
on the front panel. When the oven is turned off,
the end of cooking programmer can be used as
a normal timer.

Digital cooking programmer

(Fig. 1b)
It enables oven programming in the
following modes:
– delayed start of cooking with set duration,
– immediate start of cooking with set
duration;
– timer.
Setting the digital clock
When the appliance has been connected to the
mains or after a power failure the display will
flash on: „0.00".
X X
Press the + and - buttons together for a few
seconds. The time of day can be adjusted
with the + and - buttons, while the dot
between the hours and minutes flashes.
„ „
If the time setting mode is selected
when an automatic programme is
active, the automatic programme
is cancelled.
Possible time adjustments can be made by
repeating the steps described above.
MA 82 M _/F / MA 86 M _/F
Acoustic signal frequency modification
The frequency of the acoustic signal can be
changed if a cooking cycle is not programmed
(therefore the display shows the time of day).
X X
Press the + and - buttons (from the time
modification menu) together.
X X
Press Mode or Set to select the menu for
modifying the acoustic signal frequency.
X X
The acoustic signal frequency can be
modified by repeatedly pressing the Mode
or Set button; „ton1", „ton2", „ton3" will
appear on the display.
Manual oven operation
Once the time has been set, the programmer
automatically switches to manual mode.
Starting delayed cooking with set duration
X X
When the time of the day is displayed,
press the Mode or Set button twice to set
a duration.
X X
Then press it again to set the end of
cooking time.
X X
Set the required time with the + and -
buttons.
„ „
„ „
„ „
„ „
„ „
„ „
„ „
– 11 –
During duration or end time
adjustment mode selection, the Auto
symbol remains lit.
Once a programme duration is set, the
end time cannot be decreased.
Likewise, the duration of a programme
cannot be prolonged once the end
time is set.
The end time and duration settings
define programme start time
as follows:
start time = end time - duration.
After setting the duration and end time,
the display still shows the end time.
The programme starts when the time
of day coincides with the start time:
the Auto symbol lights up steadily and
the symbol starts flashing.
After the start of cooking, the display
shows the countdown. If only the end
of cooking time is selected
(the duration is = 0), cooking starts
and the display shows the countdown.
EN