VOLTCRAFT Energy Control 3000 USB Bedienungsanleitung Seite 46

4. Use the T2 button to switch to the minute digit which then blinks. Set the current minute
using the T3 button.
5. Use the T2 button to switch to the year digits, which then blink. Set the current year using
the T3 button.
6. Use the T2 button to switch to the month digit, which then blinks. Set the current month using
the T3 button.
7. Use the T2 button to switch to the day digit, which then blinks. Set the current date using
the T3 button.
8. Finally, press the T2 button again. Now, "SYnc" appears in the display.
Now, all sensors in operation in the reception area are automatically recorded and saved.
This process lasts approx. 12 minutes.

During this time, operation of the device is not possible.
Since the sensors transmit data every 5 minutes, the reception of all available sensors is
guaranteed during this time.
9. After the synchronization has been completed, the basic display is shown:
A Reception display
B Sensor type
C Sensor address
The following data appear:
Upper display area: Energy (kWh) or volume (m³)
Lower display area: Costs (Euro) according to pre-set cost factor

At initial operation, the data of the sensor with the lowest (numerical) address
are displayed (in the example illustration above, this is the gas meter sensor).
46
A
B
C