Care And Cleaning; Technical Data - Electrolux ASB8000 Gebrauchsanweisung

822 949 412_ASB8000.book Seite 33 Donnerstag, 29. Mai 2008 8:18 08
When processing hot liquids the
1
blender tank can become very
warm, please take care to protect
your hands.
When processing hot liquids steam
is generated, please take care to
avoid burns. Ensure that the steam
is allowed ventilate out trough the
lid or the hole for the filler cup.
Handy Blending Hints
• Food items for blending should be
cut into cubes (approximately 2-
3 cm), this will assist in achieving
an even result.
• To ensure efficient mixing when
blending dry mixtures, it may be
necessary to stop the blender and
push ingredients down the sides of
the blender tank with a spatula.
• When making bread crumbs, use 2
to 3 day old bread, to minimise the
possibility of clumping. If only fresh
bread is available, dry it out for a
few minutes in a low heated oven.
• When blending a variety of ingredi-
ents together, blend the liquids
first, then add dry ingredients.
• Always ensure stones are removed
from fruit and bones from meat as
these can harm the blades.
• Don't allow a used blender to sit
for too long as the food will dry
onto the blades, making it difficult
to clean. If you can't clean the
blender straight away, pour some
warm water in it and allow to soak.

Care and Cleaning

Before cleaning the blender, take
1
the plug out of the socket.
Make sure that no liquids get
1
inside the motor housing!
1 Clean the housing with a damp
cloth. Never immerse in water or
clean under running water.
The blender tank and blade
3
assembly can be cleaned quickly
and safely using the PULSE But-
ton.
0 Pour warm water into the blender
tank, with a few drops of washing-
up liquid.
0 Mix the water and wahing-up
liquid, by pushing the PULSE But-
ton briefly.
0 Finally, rinse the blender tank
under running water.
If necessary, the blade assembly
3
can also be cleaned separately.
Be careful when rinsing the blade
1
assembly (The blades are sharp!).
Use only water and washing-up
liquid.
When replacing the blade assem-
bly, turn it clockwise using the
filler cup (Fig. 1/A) as tool. See par-
agraph „Assembling the Blender"
on page 31.
All removable parts (blender lid,
3
filler cup, rubber seal, blade
assembly and blender tank) can be
cleaned in the dishwasher.

Technical Data

Mains voltage: 230 – 240 V / 50 Hz
Power consumption:
This appliance conforms with the
;
following EC Directives:
• Low Voltage Directive
2006/95/EC
• EMC Directive 89/336/EEC with
amendments 92/31/EEC and
93/68/EEC
g
600 W
33