Installing The Special Driver - Roland Edirol UA-700 Audio Capture Benutzerhandbuch

Getting Connected and Installing Drivers (Macintosh)

Installing the special driver

You must install the MIDI driver even if you will be using only audio on the
UA-700. Be sure to install the MIDI driver.
Use either OMS or FreeMIDI as the MIDI driver.
If you are using OMS ..................................................... (p. 42)
If you are using FreeMIDI ............................................. (p. 47)
* Either OMS or FreeMIDI must be installed in your Macintosh, as appropriate for
the sequencer software you are using.
* If the power of the UA-700 is turned on, a message like the following will appear when
the Macintosh is started up. Perform the steps described below as appropriate for the
message that is displayed.
If the screen indicates:
"Driver required for USB device 'unknown device' is not available. Search for driver on
the Internet?"
If the screen indicates:
"Software required for using device 'unknown device' cannot be found. Please refer to
the manual included with the device, and install the necessary software"
Installing the UA-700 driver (OMS)
Use the following procedure to install the UA-700 driver.
The included UA-700 OMS driver is an add-on module for using the UA-700
with OMS. In order for you to use it, OMS must already be installed on the
hard disk from which you started up.
If you would like to learn more about OMS, refer to OMS_2.3_Mac.pdf in the
OMS Driver folder within the Driver E folder of the CD-ROM. You will need
the Adobe Acrobat Reader in order to view OMS_2.3_Mac.pdf.
* Disconnect the UA-700 from the Macintosh before you perform the installation.
1
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure to exit this as well.
2
Prepare the CD-ROM.
Insert the CD-ROM into the CD-ROM drive.
42
click [Cancel].
click [OK].
OMS can be found in the
OMS Driver folder within
the Driver E folder of the
CD-ROM.