Roland Edirol UA-700 Audio Capture Benutzerhandbuch Seite 28

Getting Connected and Installing Drivers (Windows)
7
Use the USB cable to connect the UA-700 to your computer.
1. With the power switch turned OFF, connect the AC adaptor to the
UA-700.
2. Connect the AC adaptor to an electrical outlet.
3. Use the USB cable to connect the UA-700 to your computer.
fig.advance-on
8
Set the UA-700's ADVANCE (mode select)
switch to the ON position.
9
Set the UA-700's power switch to the ON
position.
Near the task bar, your computer will indicate "Found New Hardware".
Please wait.
fig.05-15e_30
10
If you are using Windows 98, an
Insert disk dialog box will
appear.
Click [OK].
fig.05-16e_30
11
The New Hardware Found
dialog box will appear.
In the Copy files from field, type
the folder name that is shown in
the SetupInf dialog box, and
click [OK].
D:\DRIVER\USB_ME98
* The drive name "D:" may be different depending on your system. Type the name of
your CD-ROM drive.
12
Once the driver has been installed, the New Hardware Found dialog box
will close.
In the SetupInf dialog box, click [OK]. The SetupInf dialog box will close.
Next, you need to make the driver settings.
( Settings and checking (p. 34))
28
Once the connections
have been completed,
turn on power to your
various devices in the
order specified. By
turning on devices in the
wrong order, you risk
causing malfunction and/
or damage to speakers
and other devices.
Advance mode is
ON
This unit is equipped
with a protection circuit.
A brief interval (a few
seconds) after power up
is required before the unit
will operate normally.
If you are using
Windows 98 and the
Insert disk dialog box
dose not appear, please
read The "Insert Disk"
dialog box does not
appear (p. 245).
If the New Hardware
Found dialog box does not
appear, re-install the
driver using the same
procedure as described in
The "Insert Disk" dialog
box does not appear
(p. 245).