Recording A Keyboard - Roland Edirol UA-700 Audio Capture Benutzerhandbuch

Application guide

Recording a keyboard

Here's how your keyboard performance can be sent to the computer as audio data. The audio data
can be recorded on your sequencer software.
fig.keyboard
Turn PAD
on
You can use phone plug cables to connect your keyboard (or other device) to the Mic input jacks.
If you set the STEREO/MONO select switch to the STEREO position, the sound that is input from
MIC 1 will be recorded on the left channel, and the sound from MIC 2 will be recorded on the right
channel.
If you set this to the MONO position, the recording will be monaural.
Use the Input sensitivity knobs to adjust the input level. For the best-quality recording, use the
input sensitivity knobs to adjust the level until it is as high as you can get it without causing the
Input peak indicator to light.
Turn on the Input monitor switch, and use the Input monitor knob to adjust the monitor volume.
Do not connect anything to the input jacks that you are not using.
* Mic effects cannot be applied if you are using 96 kHz PLAY/REC.
Only the COMPRESSOR & DE-ESSER and NOISE SUPPRESSOR & EQ effects can be applied.
136
OUTPUT
Select STEREO
Adjust the
input level
Signal flow
Keyboard
or MONO
Turn this ON if you want to
monitor the input directly